Firewire® Polysulfone (PSU)
Product Name: PSU
Product Use: 3D Printing Filament
Manufacturer/Supplier: Rev1Tech
Address: 904 36th Street, Suite B, Grand Rapids MI 49500 USA
Contact Email: [email protected]
Telephone: +248-707-2950
Emergency Telephone Number: +248-707-2950
1. PRODUCT AND SUPPLIER INFORMATION
| Product Identification |
|
|---|---|
| Supplier Information |
|
2. HAZARDS IDENTIFICATION
Regulation (EC) NO 1272/2008: Not classified as a dangerous product
- Physical Hazards: None
- OSHA Regulatory Status: This product is not considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)
3. COMPOSITION/INFORMATION ON INGREDIENTS
| Components | CAS No. | Concentration Range (%) |
|---|---|---|
| Phenol, 4,4`-(1-methylethylidene)bis-, polymer with 1,1`-sulfonylbis[4-chlorobenzene] | 25154-01-2 | 100 |
4. EMERGENCY FIRST AID
- Eyes: Flush with water. Consult physician if symptoms persist.
- Skin Contact: Wash with soap and water. For thermal burns from molten polymer, immediately flush with cold water. Do not attempt to remove cooled polymer from skin. Obtain medical attention.
- Inhalation: Leave exposed area and seek fresh air. If irritation persists seek medical attention.
- Ingestion: Not likely due to nature of product. If ingested, drink plenty of water. Do not induce vomiting. Consult a physician if symptoms persist.
5. FIRE AND EXPLOSION HAZARD
- Extinguishing Media: Water spray, dry powder, and foam. Carbon dioxide (CO2).
- Safety Precautions for Persons exposed to products of combustion should wear NIOSH approved self-contained breathing apparatus and full protective equipment.
Click here to shop ThermaX™ PSU.