SimuBone™ Bone Simulation Filament
| Physical Properties | Standard | Unit | Typical Value |
|---|---|---|---|
| Density | ISO 1183 | g/cc | 1.34 |
| Mechanical Properties | . Standard | Unit | Typical Value |
|---|---|---|---|
| Tensile Strength, Break | ISO 527 | MPa | 65 |
| Tensile Modulus | ISO 527 | . MPa | 3410 |
| Tensile Elongation, Break | ISO 527 | % | 4 |
| Flexural Strength | . ISO 178 | MPa | 122 |
| Flexural Modulus | ISO 178 | MPa | . 3355 |
| Thermal Properties | Standard | Unit | Typical Value |
|---|---|---|---|
| Glass Transition Temperature (Tg) | DSC | °C | 55 |
| Deflection Temperature at 0.45 MPa (66psi) | ISO 75 | °C | 89 |
| Certifications | Efficacy Rate |
|---|---|
| Certified Antibacterial | 99.9% |
Disclaimer: The technical data contained on this data sheet is furnished without charge or obligation and accepted at the recipient’s sole risk. This data should not be used to establish specification limits or used alone as the basis of design. The data provided is not intended to substitute any testing that may be required to determine fitness for any specific use.
Printed Specimen Conditions
- Printer: Open Source FDM/FFF
- Nozzle: 0.4mm
- Layer Height: 0.25mm
- Infill: 100%, +/- 45°
- Extrusion Temp: 230°C
- Bed Temp: 23°C
- Specimen Orientation: XY Flat
Visit our website for more information: www.Rev1Tech.com
Click here to shop SimuBone Bone Modeling Filament.