Product Description
PETG carbon fiber raw material is based on PETG raw material with carbon fiber for blending modification, mainly used in the field of 3D printing.
Form
Pellet, 25kg/bag
Key Properties
- 15-30% higher strength than ordinary PETG
- High rigidity and excellent toughness
- Excellent heat resistance and short processing cycle
- Excellent hydrolysis resistance and product stability
- Good machinability
Physical Properties
| Performance | Unit | Test Standards | Typical Value |
|---|---|---|---|
| Density | g/cm³ | ASTM D-792 | 1.25 |
| Melting Index (170°C, 2160g) | g/10min | ASTM D-1238 | 10 |
| Hardness | Rockwell R | ASTM D-785 | 119 |
| Melting Point | °C | DSC | 190-210 |
| Vica Softening Point A/120 | °C | ASTM D-648 | 72 |
| Tensile Strength | MPa | ASTM D-638 | 56 |
| Bending Strength | MPa | ASTM D-790 | 88 |
| Bending Modulus | MPa | ASTM D-790 | 2280 |
| Notch Impact Strength | J/m | ASTM D-256 | 0.78 |
| Water Absorption | % | ASTM D-570 | <1 |
Processing Parameters
| Zone | Temperature (°C) | Temperature (°F) |
|---|---|---|
| Feeding Section | 170-185 | 320-329 |
| Compression Section | 185-205 | 329-338 |
| Measuring Section | 195-215 | 329-338 |
| Die Section | 190-205 | 329-347 |
Storage Recommendations
Store in dry, well-ventilated warehouse. Storage temperature should not exceed 70°C. Protect from moisture and rain.
Drying Process
Pre-dry if moisture content exceeds 0.3%. Typical drying conditions: 3 hours at 70°C.
* Above data are typical values and should not be interpreted as technical indicators to determine quality technology.
© 2025 Rev1 Technologies | Technical Data Sheet PETG Carbon Fiber