It is highly recommended to use the PolyBox™ when printing with PolyLite™ PETG and to store it in the resealable bag.
Based on 0.4 mm nozzle and Simplify 3D v.4.0. Printing conditions may vary with different nozzle diameters.
Nozzle Temperature
230 – 240 °C
Build Surface Material
BuildTak®, Glass
Build Surface Treatment
Glue
Build Plate Temperature
70 - 80 °C
Cooling Fan
OFF-20%
Printing Speed
30-50 mm/s
Raft Separation Distance
0.14 mm
Retraction Distance
1 mm
Retraction Speed
20 mm/s
Environmental Temperature
Room temperature
Threshold Overhang Angle
60°
Recommended Support Material
PolyDissolve™ S1
The typical values presented in this data sheet are intended for reference and comparison purposes only. They should not be used for design specifications or quality control purposes. Actual values may vary significantly with printing conditions. End-use performance of printed parts depends not only on materials, but also on part design, environmental conditions, printing conditions, etc. Product specifications are subject to change without notice.
Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/recycling practices of Polymaker materials for the intended application. Rev1Tech makes no warranty of any kind, unless announced separately, to the fitness for any use or application. Rev1Tech shall not be made liable for any damage, injury, or loss induced from the use of Rev1Tech materials in any application.
Click here to shop PolyLitePETG.