PolyFlex TPU95 Technical Data Sheet

Technical Data Sheet

Identification

Product Name	PolyFlex TPU95
Product Use	3D Printing Filament
Manufacturer/Supplier	JF Polymers (Suzhou) Co., Ltd.
Address	2901 Auburn Rd, Auburn Hills, MI 48326
Contact Email	[email protected]
Telephone	+248-707-2950
Emergency Telephone Number	+248-707-2950

Material Properties

Property	Standard	Value
Density	ISO1183, GB/T1033	1.20-1.24 g/cm3 at 23 °C
Melt index	210°C, 1.2 kg	3-6 g/10min
Light transmission	N/A	N/A
Flame retardancy	N/A	N/A
Effect of weak acids	N/A	Not resistant
Effect of strong acids	N/A	Not resistant
Effect of weak alkalis	N/A	Not resistant
Effect of strong alkalis	N/A	Not resistant
Effect of organic solvent	N/A	No data available
Effect of oils and grease	N/A	No data available
Equilibrium water absorption	N/A	0.82%

Mechanical Properties

Property	Standard	Value
100% modulus (X-Y)	ISO 37, GB/T 528	9.4 ± 0.3 MPa
Young’s modulus (X-Y)	ISO 37, GB/T 528	29 ± 2.8 MPa
Elongation at break (X-Y)	ISO 37, GB/T 528	330.1 ± 14%
Shore hardness	ISO 7619-1, GB/T 531.1	95A

Printing Settings

Parameter	Value
Nozzle temperature	210 – 230 (℃)
Build surface material	BuildTak®, Glass, Blue Tape
Build surface treatment	PVA or PVP glue, Magigoo
Build plate temperature	25 - 60 (˚C)
Cooling fan	ON
Printing speed	20-40 (mm/s)
Raft separation distance	0.2 (mm)
Retraction distance	3 (mm)
Retraction speed	40 (mm/s)
Environmental temperature	Room temperature
Threshold overhang angle	35 (˚)
Recommended support material	PolySupport™ and PolyDissolve™ S1

Additional Printing Parameters

Parameter	Value
Printing temperature	225 °C
Bed temperature	30 °C
Shell	2
Top & bottom layer	4
Infill	100%
Environmental temperature	25 °C
Cooling fan	ON

The typical values presented in this data sheet are intended for reference and comparison purposes only. They should not be used for design specifications or quality control purposes. Actual values may vary significantly with printing conditions. End-use performance of printed parts depends not only on materials, but also on part design, environmental conditions, printing conditions, etc. Product specifications are subject to change without notice.

Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/recycling practices of Polymaker materials for the intended application. Rev1Tech makes no warranty of any kind, unless announced separately, to the fitness for any use or application. Rev1Tech shall not be made liable for any damage, injury, or loss induced from the use of Rev1Tech materials in any application.
Click here to shop PolyFlexTPU95.