Product Identification
Product Name: 3dxstat ESD_PLA
Product Use: 3D Printing Filament
Manufacturer/Supplier: Rev1Tech
Address: 2901 Auburn Rd, Auburn Hills, MI 48326
Contact Email: [email protected]
Telephone: +248-707-2950
Emergency Telephone Number: +248-707-2950
1. PRODUCT AND SUPPLIER INFORMATION
Product Name: 3dxstat ESD_PLA
Chemical Name: Polylactic Acid Polymer (PLA)
Recommended Use: Additive manufacturing
Supplier Information:
- Rev1Tech
- 904 36th Street, Suite B
- Grand Rapids, MI 49500
- Phone: +248-707-2950
- Email: [email protected]
2. HAZARDS IDENTIFICATION
Regulation (EC) NO 1272/2008: Not classified as a dangerous product
Physical Hazards: None
OSHA Regulatory Status: This product is not considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)
3. COMPOSITION/INFORMATION ON INGREDIENTS
| Components | CAS No. | Concentration Range (%) |
|---|---|---|
| PLA Resin | 9051-89-02 | >90 |
| Carbon Additives | 1333-86-4 | <10 |
4. EMERGENCY FIRST AID
- Eyes: Flush with water. Consult physician if symptoms persist.
- Skin Contact: Wash with soap and water. For thermal burns from molten polymer, immediately flush with cold water. Do not attempt to remove cooled polymer from skin. Obtain medical attention.
- Inhalation: Leave exposed area and seek fresh air. If irritation persists seek medical attention.
- Ingestion: Not likely due to nature of product. If ingested, drink plenty of water. Do not induce vomiting. Consult a physician if symptoms persist.
5. FIRE AND EXPLOSION HAZARD
- Extinguishing Media: Water spray, dry powder, and foam. Carbon dioxide (CO2)
- Safety Precautions: Persons exposed to products of combustion should wear NIOSH approved self-contained breathing apparatus and full protective equipment.
16. MISCELLANEOUS INFORMATION
Prepared by: Business Management
Issued: 08/01/2022
This information set forth herein has been gathered from standard reference materials and/or supplier test data and is, to the best knowledge and belief of Rev1Tech, accurate and reliable. Such information is offered solely for your consideration, investigation and verification, and it is not suggested or guaranteed that the hazard precautions or procedures mentioned are the only ones which exist. Rev1Tech makes no warranties, expressed or implied, with respect to the use of such information or the use of the specific material identified herein in combination with any other material or process, and assumes no responsibility therefore.