Technical Data Sheet
3DXSTAT™ ESD-Safe Nylon 12 (PA12) 3D Filament
| Physical Properties |
Standard |
Unit |
Typical Value |
| Density |
ISO 1183 |
g/cc |
1.14 |
| Mechanical Properties |
Standard |
Unit |
Typical Value |
| Tensile Strength, Break |
ISO 527 |
MPa |
68 |
| Tensile Modulus |
ISO 527 |
MPa |
6900 |
| Tensile Elongation, Break |
ISO 527 |
% |
3.8 |
| Flexural Strength |
ISO 178 |
MPa |
81 |
| Flexural Modulus |
ISO 178 |
MPa |
6700 |
| Thermal Properties |
Standard |
Unit |
Typical Value |
| Glass Transition Temperature (Tg) |
DSC |
°C |
158 |
| Deflection Temperature at 0.45 MPa (66psi) |
ISO 75 |
°C |
142 |
| Electrical Property |
Standard |
Unit |
Typical Value |
| Surface Resistance |
ASTM D257 |
Ohm/sq |
>103 - 107 |
Disclaimer: The technical data contained on this data sheet is furnished without charge or obligation and accepted at the recipient’s sole risk. This data should not be used to establish specification limits or used alone as the basis of design. The data provided is not intended to substitute any testing that may be required to determine fitness for any specific use.
Basic Printing Recommendations
- Recommended Nozzle Diameter: Minimum 0.4mm
- Layer Height: 0.25mm or 60% of nozzle diameter
- Extrusion Temp: 265 - 285°C
- Bed Temp: 90-110°C
Please note: Extrusion temperatures play a large role in surface resistance of a printed part. Higher extrusion temperatures yield lower surface resistance values. Likewise, lower extrusion temperatures yield higher surface resistance values. Therefore, the surface resistance of a printed part can be 'tuned' to your desired level of conductivity by modifying extrusion temp up or down.