CreatBotPro-HS Filament Sensor RightGenuine CreatBot Replacement Part
Pro-HS Filament Sensor, Right, for D400 HS, D600 Pro3 HS, D1000 Pro HS, D800 Ultra and D1200 Ultra
The CreatBot Pro-HS right filament sensor (part 116013) is the OEM sensor that watches the right side filament feed on CreatBot's Pro HS and Ultra dual extruder printers. Each extruder has its own feed and its own sensor. When the right spool empties or the filament breaks, this sensor signals the printer so the job can pause and wait for a reload. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot Pro-HS Filament Sensor Right, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
What the right sensor does for you
If the right extruder carries support or a second material, a runout there can ruin the whole part. The sensor lets the printer stop in time.
The same part fits five current CreatBot models, which keeps spares simple.
Installs in place of the original with no modification.
Signs the right sensor is failing
The right extruder reports a runout with filament present.
The right spool empties without a pause.
The sensor body, mount or cable is damaged.
A quick check: if the same symptom follows the right side but the left sensor works normally with the same filament, the right sensor is the likely cause.
Compatible CreatBot 3D printers
The left side sensor for these printers is part 116012.
Installation tips
Switch off the printer and unload the right filament. Photograph the sensor and its cable before removal, install the new sensor in the same position, and reconnect. Test by loading filament on the right side and then pulling it back to trigger the runout alert.
CreatBot Pro-HS Filament Sensor Right Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot Pro-HS Filament Sensor Right — Questions
Do I need both the left and right sensors?
Only replace the side that has failed. The left sensor is part 116012 and the right is 116013.
Does it fit the D1000 HS?
No. The D1000 HS uses its own sensor, part 116002.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 116013, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.