CreatBotPI Control ModuleGenuine CreatBot Replacement Part
PI Control Module for D600 Pro2 HS, D1000 HS and F430 NX
The CreatBot PI (part 111024) is an OEM control electronics module for the CreatBot D600 Pro2 HS, D1000 HS and F430 NX. It is part of the printer's control system and works alongside the main control board. When a control module fails, the printer can stop responding, refuse to start a job or behave unpredictably, and a genuine CreatBot replacement is the reliable way to return it to factory behavior. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PI Control Module, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the CreatBot PI may need replacing
The printer does not finish starting up, or the touchscreen does not load the normal interface.
The printer loses its connection to the control electronics during operation.
Visible damage on the module, such as a burnt component or a broken connector.
Many faults look alike from the outside. A failed power supply, a loose cable or a fault on the motherboard can cause the same symptoms. Contact Rev1 support before you order, and we will help you confirm which part is at fault.
Compatible CreatBot 3D printers
These printers each use their own motherboard: D600 Pro2 HS (111001), D1000 HS (111002) and F430 NX (111003). The newer D600 Pro3 HS is not on this list; it has its own Klipper host (111022).
Ordering the right part
CreatBot also lists its STM32 core board under part number 111024. When you order, make sure you are asking for the CreatBot PI, and mention your printer model. If you are not sure which module has failed, send Rev1 support a photo of the electronics bay and a description of the fault.
Installation
Power the printer off and unplug it before opening the electronics bay. Photograph every connector and cable route before you disconnect anything, and use anti-static precautions when handling the module. After installation, check the firmware and software versions with Rev1 support. If your printer is under warranty, contact us first: Rev1 can perform the replacement as your certified CreatBot service provider.
CreatBot PI Control Module Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PI Control Module — Questions
Is the CreatBot PI the same as the motherboard?
No. It is a separate module. The motherboards for these printers are 111001, 111002 and 111003.
Will it work in my D600 Pro3 HS?
It is not listed for the D600 Pro3 HS. That printer uses the Klipper host, part 111022.
Can Rev1 install it for me?
Yes. Rev1 is a certified CreatBot service provider and can diagnose, replace and test the module.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.