CreatBotPEEK-300 Z-Axis BeltGenuine CreatBot Replacement Part
For the CreatBot PEEK-300
The CreatBot PEEK-300 Z-axis belt (part 141008) is the OEM belt used in the Z drive of the CreatBot PEEK-300. The PEEK-300 is CreatBot's machine for PEEK and other high-performance polymers, and those materials are often used for functional parts with tight tolerances. The Z belt is what keeps each layer step the same size, so it has a direct effect on part height, layer bonding and surface finish. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PEEK-300 Z-Axis Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the Z-axis belt needs replacing
Visible banding or inconsistent layer lines up the walls of a part.
Part heights no longer match the model.
One side of the build plate sits higher than the other after homing.
The Z axis makes a clicking or skipping noise, or the belt looks cracked or worn.
Compatible CreatBot 3D printer
This belt is made for the PEEK-300. The PEEK-250 uses its own Z axis belt, part 141009.
Planned replacement
PEEK prints are often long and the material is valuable, so a Z failure mid-print wastes hours of machine time and material. If your PEEK-300 runs most days, inspect the Z belt during routine maintenance and replace it at the first sign of cracking or lost tension rather than waiting for a failed print. Keeping one on the shelf avoids downtime.
Installation tips
Wait until the chamber and heated parts are fully cool, then power off and unplug the printer. Support the build plate before releasing the belt, and mark each pulley so the Z drive goes back together in the same position. Fit and tension the new belt, home the printer, run the leveling routine and print a short test part.
CreatBot PEEK-300 Z-Axis Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PEEK-300 Z-Axis Belt — Questions
Will this belt fit a PEEK-250?
No. The PEEK-250 uses Z axis belt part 141009.
How do I know the belt and not the leveling is the problem?
If the plate re-levels correctly and then drifts again, or the belt shows wear or jumped teeth, the belt is the likely cause. Rev1 support can help you confirm it.
Can Rev1 install it?
Yes. Rev1 Technologies is a certified CreatBot service provider and can replace the Z belt and set the printer up afterwards.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.