CreatBotPEEK-300 Heating PTCGenuine CreatBot Replacement Part
PTC chamber heater for the CreatBot PEEK-300
The CreatBot PEEK-300 heating PTC (part 173008) is the chamber heater for the CreatBot PEEK-300. The PEEK-300 is built around high temperature polymers, and those materials only print well in a hot chamber. A hot enclosure keeps freshly deposited plastic close to the temperature of the layers below it, which gives strong layer fusion and lets the finished part cool without internal stress cracking it apart. The CreatBot part name is marked *2, indicating two heaters. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PEEK-300 Heating PTC (Chamber Heater), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the heater needs replacing
The chamber does not reach its set temperature, or the printer reports a heater fault.
Parts that used to print cleanly now crack or delaminate.
Scorch marks, damaged leads or a burnt smell at the heater.
Compatible CreatBot 3D printer
The PEEK-300 also has a separate filament heating PTC, part 173014. The PEEK-250 uses its own chamber heater, part 173007.
Why replace with the genuine heater
Built for the PEEK-300. The same heater, mounting and wiring the printer was designed around.
PTC heating element. A positive temperature coefficient heater limits its own output as it warms, which makes it a practical way to heat an enclosure.
Restores part quality. PEEK, PEI and similar materials are unforgiving of a weak chamber heater. Getting full chamber heat back is the first step to consistent parts.
Installation tips
Turn the printer off, unplug it and give the chamber plenty of time to cool. Photograph each heater connection, replace the heaters in the same positions, and secure the wiring away from the motion system and hot surfaces. Run chamber heating once and confirm it reaches temperature before starting a production print. Under warranty? Contact Rev1 first, as your certified CreatBot service provider.
CreatBot PEEK-300 Heating PTC (Chamber Heater) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PEEK-300 Heating PTC (Chamber Heater) — Questions
Is this the filament heater?
No. The PEEK-300 filament heating PTC is part 173014. This part heats the build chamber.
Will it fit the PEEK-250?
No. The PEEK-250 uses part 173007.
Is it a genuine CreatBot part?
Yes. CreatBot part 173008, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.