CreatBotPEEK-300 Chamber HeaterGenuine CreatBot Replacement Part
Build chamber heater for the CreatBot PEEK-300
The CreatBot PEEK-300 chamber heater (part 182008) is the OEM heater for the build chamber of the CreatBot PEEK-300. The PEEK-300 exists to print PEEK, PEI and similar high performance polymers, and the heated chamber is a core part of that capability. These materials shrink strongly as they cool. A hot chamber keeps the part at an even temperature through the whole print, which is what prevents warping, cracking and weak layer bonds. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PEEK-300 Chamber Heater (Build Chamber Heater), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs it needs replacing
The chamber heats slowly or never reaches its set point, the printer shows a chamber heating error, or PEEK parts begin to warp and crack at settings that used to work. Check for discolored leads or a loose connector. Sensor and fuse faults look similar, so Rev1 support can help you test before ordering.
Compatible CreatBot 3D printer
The PEEK-250 uses a different chamber heater, part 182007. The PEEK-300 filament chamber heater, which keeps spools dry, is a separate part, 182014.
Why the chamber heater is critical on the PEEK-300
Part strength. Good layer bonding in PEEK depends on the surrounding temperature, not only the nozzle.
Dimensional accuracy. Even cooling keeps large and thick parts closer to their designed shape.
Fewer failed jobs. High performance filaments are slow to print, so a failed chamber heater can waste many hours of machine time.
Genuine CreatBot part designed for the PEEK-300 chamber.
Installation tips
Switch off and unplug the printer and let the chamber cool completely; a high temperature chamber stays hot for a long time. Photograph the wiring and terminal layout, replace the heater in the same position with the original hardware, and make sure leads are secure and away from hot surfaces and moving parts. Run a full chamber heat cycle with the door closed and confirm the chamber reaches and holds temperature before a PEEK job.
CreatBot PEEK-300 Chamber Heater (Build Chamber Heater) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PEEK-300 Chamber Heater (Build Chamber Heater) — Questions
Is this the filament chamber heater?
No. This heats the build chamber. The PEEK-300 filament chamber heater is part 182014.
Will it fit the PEEK-250?
No. The PEEK-250 uses part 182007.
Can Rev1 replace it for me?
Yes. Rev1 Technologies is a certified CreatBot service provider and can diagnose, replace and test the heater.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 182008, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.