CreatBotPEEK-250 X/Y-Axis BeltGenuine CreatBot Replacement Part
X/Y-axis timing belt for the CreatBot PEEK-250
The CreatBot PEEK-250 X/Y-axis belt (part 142002) is the OEM timing belt used for X and Y motion on the CreatBot PEEK-250. These are the axes that trace every outline and infill path, so belt condition shows up directly in wall quality and dimensional accuracy. On a machine built for PEEK and other high-performance materials, where parts are often functional and toleranced, a worn motion belt is worth replacing early. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PEEK-250 X/Y-Axis Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs an X/Y belt needs replacing
Layer shifts in X or Y, often during fast travel moves.
Ghosting or ripples next to sharp corners and edges.
Holes and features measure out of size in one direction.
Visible damage: cracking, fraying, worn teeth or a stretched belt that will not hold tension.
Compatible CreatBot 3D printer
The PEEK-300 uses a different X/Y axis belt, part 142001. The PEEK-250 Z axis has its own separate belt.
Replace one belt or both?
Because the same part serves the X and Y axes, it makes sense to inspect both belts whenever one shows wear. Belts of the same age wear at similar rates, and matched tension on X and Y is part of what keeps parts square. Replacing both in one session means a single setup and calibration instead of two.
Installation tips
Let the printer cool, then power it off and unplug it. Photograph the belt routing and the clamp at each end. Fit the new belt along the same path, seat the teeth fully in the pulley and set the tension so the belt is firm without being drum tight. Move the axis by hand through its full travel, then home the printer and print a calibration part to check X and Y dimensions.
CreatBot PEEK-250 X/Y-Axis Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PEEK-250 X/Y-Axis Belt — Questions
Does this one belt work on both the X and Y axis?
Yes. CreatBot lists part 142002 as the X/Y axis belt for the PEEK-250.
Will it fit my PEEK-300?
No. The PEEK-300 uses part 142001.
Is this a genuine CreatBot part?
Yes, CreatBot part 142002, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.