CreatBotPEEK-250 MotherboardGenuine CreatBot Replacement Part
PEEK-250 Motherboard (Main Control Board)
The CreatBot PEEK-250 motherboard (part 111004) is the OEM main control board for the CreatBot PEEK-250, the CreatBot printer built for PEEK and other high performance polymers. Printing these materials depends on tightly controlled heating of the hotend and build environment, and the motherboard is what runs that control along with the motion system and the printer's sensors. A genuine board keeps the PEEK-250 working exactly as CreatBot designed it. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot PEEK-250 Motherboard, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs your motherboard may need replacing
The PEEK-250 does not boot, or the screen does not respond to input.
Heating or motion faults that persist after the heater, sensor or motor has been tested and found good.
Visible damage on the board, such as burnt components, a damaged connector or discoloration.
A power supply, cable or extruder board fault can look the same. Contact Rev1 support before you order and we will help you confirm the board is the cause.
Compatible CreatBot 3D printer
The PEEK-300 uses different boards: the 8-bit boards (parts 111016 and 111017) or the 32-bit board (part 111018).
Why use a genuine board on a PEEK printer
High temperature printers put more demand on their electronics than a desktop machine. Heater outputs, temperature readings and safety behavior all run through the motherboard and its firmware. A non-original board may not match the PEEK-250's wiring or firmware, which risks poor temperature control or worse. The genuine CreatBot board removes that uncertainty.
Installation
Let the printer cool fully, then power it off and unplug it before opening the electronics bay. Photograph every connector before you disconnect anything and use anti-static precautions. After installation, check the firmware with Rev1 support and verify heating on a short test before a full PEEK job. If your printer is under warranty, contact us first: Rev1 can perform the replacement as your certified CreatBot service provider.
CreatBot PEEK-250 Motherboard Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot PEEK-250 Motherboard — Questions
Will it work in a PEEK-300?
No. The PEEK-300 uses part 111016, 111017 or 111018, depending on its electronics.
Is this the same board my PEEK-250 shipped with?
Yes. It is the genuine CreatBot PEEK-250 motherboard, part 111004.
Can Rev1 install it for me?
Yes. Rev1 is a certified CreatBot service provider and can diagnose, replace and test the board.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.