CreatBotHS Reduction Gear BearingGenuine CreatBot Replacement Part
HS Extruder Reduction Gear Bearing for D Series HS, D Series, Ultra and PEEK-300 3D Printers
CreatBot lists part 124010 as the HS Extruder Reduction Gear/Bearing. It is the OEM bearing part for the reduction gear in CreatBot's geared extruder, used on the HS and Ultra printers and on several D Series and PEEK models. Bearings let the reduction gear turn freely and stay aligned while it drives the filament. When a bearing wears, the gear runs rough, the drive loses smoothness and extrusion suffers. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot HS Reduction Gear Bearing, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs of a worn extruder bearing
Grinding, rough or notchy feel when you turn the extruder gear by hand.
Side play or wobble in the reduction gear.
Uneven extrusion or a ticking noise that follows the rotation of the gear.
Compatible CreatBot 3D printers
Which extruder gear part do I need?
CreatBot splits the HS extruder gear train into several parts. Choose by what is worn:
This part, 124010.
The flange bearing, 124011.
The reduction gear, 124009.
The complete gear set with bearings, 124008.
If you are not sure which part you have, send Rev1 a photo of the extruder and we will match it.
Installation tips
Power the printer off, let the hotend cool and remove the filament. Photograph the extruder before you open it. Press the new bearing in squarely without forcing it at an angle, then check that the gear spins freely before you close the extruder and run an extrusion test.
CreatBot HS Reduction Gear Bearing Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot HS Reduction Gear Bearing — Questions
Is this the gear or the bearing?
CreatBot names it Reduction Gear/Bearing. It is listed separately from the gear (124009) and the flange bearing (124011). Contact Rev1 if you need help confirming the match.
Does it fit the D600 Pro?
Yes. The D600 Pro is on the compatibility list above.
Is this a genuine CreatBot part?
Yes, CreatBot part 124010, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.