CreatBotF430 NX HEPA FilterGenuine CreatBot Replacement Part
For the CreatBot F430 NX
The CreatBot F430 NX HEPA filter (part 109002) is the OEM replacement filter for the air filtration system on the CreatBot F430 NX. The F430 NX is an enclosed printer, and an enclosure keeps heat in for materials that warp, but it also keeps fumes and fine particles in. The filtration system clears that air through the HEPA filter. Once the filter is loaded, it captures less and restricts airflow, which is why it is replaced as routine maintenance. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot F430 NX HEPA Filter, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Why use a genuine F430 NX filter
The filter seals in place so air goes through the media, not around it.
New HEPA media traps fine particles from printing that a clogged filter lets pass.
ABS, ASA, nylon and PC give off more odor and particles than PLA.
Generic filters cut to size often leave gaps or restrict airflow.
Compatible CreatBot 3D printer
The original F430 uses a different filter, part 109001. The F1000 uses 109009.
Filament and filter life
How long a filter lasts depends on hours and materials. PLA and PETG are gentle on a filter. ABS, ASA, nylon, PC and other engineering materials release more fumes and particles, so an F430 NX printing them daily will need filters more often. A simple routine works well: look at the filter once a month, change it when the intake side is visibly discolored or the room smells of printing, and keep one spare on hand.
Installation tips
Turn the printer off before opening the filter housing. Remove the old filter and note which way it faced. Fit the new filter in the same orientation, check that it sits evenly in its frame, and close the housing. Seal the used filter in a bag; HEPA filters are not washable or reusable.
CreatBot F430 NX HEPA Filter Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot F430 NX HEPA Filter — Questions
Will the F430 filter fit my F430 NX?
No. They are separate parts. The F430 NX needs part 109002; the F430 uses 109001.
Can I print without a filter installed?
We do not recommend it. The filter is what captures particles from printing. Replace it rather than running without one.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 109002, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.