CreatBotF430 HEPA FilterGenuine CreatBot Replacement Part
For the CreatBot F430
The CreatBot F430 HEPA filter (part 109001) is the OEM replacement filter for the original CreatBot F430. The F430 is an enclosed printer often chosen for engineering materials, and enclosed printers concentrate fumes and fine particles inside the chamber. The HEPA filter cleans that air before it reaches the room. It is a wear item: as it captures particles, the media clogs, so it needs replacing to keep working. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot F430 HEPA Filter, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the F430 filter needs changing
Or visibly loaded on the side facing the chamber.
More than it used to, especially with ABS or nylon.
Through the filtration system.
If you do not know how old the filter is, it is probably due.
Compatible CreatBot 3D printer
The F430 NX is a different model with its own filter, part 109002. The F1000 uses 109009.
F430 or F430 NX?
The F430 and F430 NX share a name but take different HEPA filters. Check the model on the printer's label or touchscreen before ordering. If it shows F430 NX, you need part 109002. If it shows F430 alone, this is the right filter. If in doubt, send Rev1 support a photo of the label and the old filter and we will confirm the part before you order.
Installation tips
Switch the printer off and open the filter housing. Note the orientation of the old filter, then remove it. Install the new filter the same way round, make sure it is fully seated with no gaps at the edges, and close the housing. Do not try to clean the old filter for reuse: washing or vacuuming HEPA media damages it. Seal it in a bag and dispose of it.
CreatBot F430 HEPA Filter Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot F430 HEPA Filter — Questions
Will this fit my F430 NX?
No. The F430 NX uses part 109002.
How often should the F430 filter be replaced?
It depends on print hours and materials. Check it monthly, and replace it sooner if you print ABS, ASA, nylon or PC regularly.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 109001, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.