CreatBotF1000 Extruder CableGenuine CreatBot Replacement Part
Extruder cable for the CreatBot F1000
The CreatBot F1000 extruder cable (part 160011) is the OEM cable for the extruder on the CreatBot F1000 large format printer. It carries the circuits that make the extruder work: heater power, the hotend temperature sensor, the fans on the print head and the extruder motor. Large format prints can run for days, and a cable fault partway through means a failed part and lost material, so a sound extruder cable matters. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot F1000 Extruder Cable, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the extruder cable needs replacing
Temperature faults or thermal errors that stop a print without a clear cause.
A temperature reading that changes when you move or touch the cable.
The extruder motor skips, buzzes or does not turn.
Print head fans that stop intermittently.
Melted, darkened or loose connector pins.
A failed heater or sensor can show the same symptoms. Measuring their resistance, or swapping in a known good part, helps confirm whether the cable is at fault. Rev1 support can walk you through it.
Compatible CreatBot 3D printer
The F1000 drag chain cable is a separate part, 160012. The F430 uses its own extruder cable, part 160005.
Installation tips
Turn the printer off, unplug it and wait for the hotend to cool. Label both ends and photograph the cable route before you remove the old cable. Install the new one along the same path, use the original tie points, and keep it clear of the heater block and moving belts. After reconnecting, heat the hotend, confirm a steady temperature reading and run a short test print.
CreatBot F1000 Extruder Cable Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot F1000 Extruder Cable — Questions
Does the F430 extruder cable fit the F1000?
No. The F430 uses part 160005. The F1000 needs part 160011.
Is the extruder cable the same as the drag chain cable?
No. They are separate parts. The F1000 drag chain cable is part 160012.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 160011, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified CreatBot service provider.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.