CreatBotF1000 E2 Extruder MotorGenuine CreatBot Replacement Part
For the CreatBot F1000
The CreatBot F1000 E2 motor (part 131031) drives the second extruder (E2) on the CreatBot F1000. On a large format printer the second extruder often carries the support material for big overhangs or a second material, so a weak E2 motor can bring down an entire build even when E1 is printing perfectly. The motor turns the drive gear that grips the filament, so its torque and step accuracy decide how reliably E2 feeds. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot F1000 E2 Extruder Motor, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
What a genuine CreatBot E2 motor gives you
The same motor the F1000 ships with, for the stock mount and cable.
E2 feeds the same way as E1, so your profiles do not need reworking.
On large parts with long overhangs.
Signs the E2 motor needs replacing
E2 does not move during load or extrude commands.
Clicking or skipping on E2 only, with a clear nozzle.
Supports print thin or stop partway through a print.
A clog, a worn drive gear or a cable fault can look the same. Rev1 support can help you confirm the cause.
Compatible CreatBot 3D printer
The first extruder uses the F1000 E1 motor, part 131030. The F1000 Z motor is part 131032.
Installation tips
Unload the E2 filament and let the hotend cool, then switch off and unplug the printer. Take photos of the wiring and the drive gear before you start. Mount the new motor the same way round as the old one, align the drive gear with the filament path and reset the tension. Extrude a test length through E2 and print a small part with supports to confirm both extruders feed evenly.
CreatBot F1000 E2 Extruder Motor Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot F1000 E2 Extruder Motor — Questions
Which motor drives the support extruder on my F1000?
That depends on how your slicer assigns materials. If support comes from the second extruder, this E2 motor (131031) is the one that drives it.
Will it fit the F430?
No. The F430 E2 motor is part 131017.
Can Rev1 replace it for me?
Yes. Rev1 is a certified CreatBot service provider and can fit and test the motor.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.