CreatBotD600 Pro3 HS Magnetic SheetGenuine CreatBot Replacement Part
D600 Pro3 HS Removable Magnetic Sheet
The CreatBot D600 Pro3 HS removable magnetic sheet (part 107023) is the OEM build sheet for the CreatBot D600 Pro3 HS. The sheet sits on the magnetic base of the bed during printing and comes off in one piece when the print is done. Flex it and the part releases, so there is no need to scrape the bed or risk damaging the part. Because every print starts here, the condition of the sheet has a direct effect on first layer quality. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro3 HS Magnetic Sheet, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs your sheet needs replacing
Parts start lifting at the corners in areas where they used to stick well.
Scratches, gouges or melted spots in the print surface.
The sheet has a crease or bend and no longer lies flat on the magnetic base.
Residue builds up that cleaning does not remove, and parts release unevenly.
Compatible CreatBot 3D printer
The older D600 Pro2 HS and D600 Pro2 use part 107002, and the D600 Pro uses 107014. The D1000 Pro HS (107024) and D400 HS (107025) have their own sheets.
Care and cleaning
Handle the sheet by its edges to keep skin oils off the print surface. Clean it with isopropyl alcohol between prints, and wash off stubborn residue rather than scraping it. When removing parts, flex the sheet in a gentle curve: a tight bend can leave a permanent crease. A second sheet lets you rotate between them and gives you a backup during long production runs.
Installation tips
Let the bed cool before removing the old sheet. Wipe the magnetic base clean, then line the new sheet up with the edges of the bed and lay it down flat. Run the bed leveling routine and a first layer test before you queue a large job.
CreatBot D600 Pro3 HS Magnetic Sheet Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro3 HS Magnetic Sheet — Questions
Will the D600 Pro2 HS sheet fit my D600 Pro3 HS?
CreatBot lists a separate part for each model. The D600 Pro3 HS uses 107023; the D600 Pro2 HS uses 107002.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 107023, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Can I print engineering filaments on it?
The sheet is the standard OEM build surface for the D600 Pro3 HS. For advice on a specific material, contact Rev1 support.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.