CreatBotD600 Pro3 HS Klipper HostGenuine CreatBot Replacement Part
For the CreatBot D600 Pro3 HS
The CreatBot D600 Pro3 HS Klipper host (part 111022) is the OEM host controller for the CreatBot D600 Pro3 HS. The D600 Pro3 HS runs Klipper firmware, and Klipper divides the control work. The host runs the Klipper software, reads the print file and calculates the motion, then sends timed step commands to the motherboard (part 111020), which drives the motors, heaters and fans. The host typically also serves the printer's interface. With a failed host, the motherboard has no instructions to follow and the printer cannot print. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro3 HS Klipper Host, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Why replace with the genuine host
The same hardware your printer shipped with, so connectors and mounting line up.
Rev1 can help you load the correct software and printer configuration after the swap.
High speed printing depends on the host keeping the motion plan ahead of the printer.
Signs the host may have failed
The touchscreen interface does not load, or the printer hangs during startup.
The interface freezes, restarts or cannot open print files.
Visible damage on the host, such as a burnt component or damaged connector.
A cable, storage or power fault can look the same. Talk to Rev1 support before ordering.
Compatible CreatBot 3D printer
The D1000 Pro HS and D400 HS use a different Klipper host, part 111023.
Installation
Power the printer off and unplug it before opening the electronics bay. Photograph each connection to the host, including the motherboard link and the display, then remove the old host. Use anti-static precautions. After installation, contact Rev1 support to confirm the software and configuration for your printer. If the printer is under warranty, contact us first: Rev1 can perform the replacement as your certified CreatBot service provider.
CreatBot D600 Pro3 HS Klipper Host Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro3 HS Klipper Host — Questions
Is the Klipper host the same as the motherboard?
No. The D600 Pro3 HS uses both. The motherboard is part 111020; this host is part 111022.
Will it fit my D1000 Pro HS?
No. The D1000 Pro HS uses Klipper host 111023.
Can Rev1 install it?
Yes. Rev1 is a certified CreatBot service provider and can diagnose, replace and test the host.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.