CreatBotD600 Pro2 X-Axis BeltGenuine CreatBot Replacement Part
X-axis timing belt for the CreatBot D600 Pro2
The CreatBot D600 Pro2 X-axis belt (part 143004) is the OEM timing belt that drives X-axis motion on the CreatBot D600 Pro2. It links the X motor to the moving carriage, so its condition shows up in every outline the printer draws. Fitting the genuine CreatBot belt gives you the same belt the printer was set up with at the factory, which keeps calibration and tension settings predictable. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 X-Axis Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the X-axis belt needs replacing
Prints shift left or right partway up.
Fine surface ripples (ringing) that appear after sharp corners.
X dimensions that drift, or parts that no longer fit their mating parts.
A belt that is cracked, frayed, glazed or missing teeth.
Compatible CreatBot 3D printer
This belt is for the D600 Pro2. The D600 Pro2 Y axis uses a Y-axis belt (143005) and a Y-axis closed loop belt (143006). The earlier D600 Pro uses X-axis belt 143001, and the D600 Pro2 HS uses 143007.
D600 Pro2 or D600 Pro2 HS?
The D600 Pro2 and the D600 Pro2 HS have similar names, but CreatBot lists a different X-axis belt for each. Check the model label on your printer before ordering. If the label says HS, order part 143007 instead. Rev1 support can help you confirm the right belt.
Installation tips
Power off and unplug the printer. Photograph how the belt runs around the pulleys and how each end is fixed at the carriage. Fit the new belt along the same path with the teeth fully seated, set the tension so it is firm with no slack, and move the carriage through its full travel by hand. Home the printer and print a dimensional test part.
CreatBot D600 Pro2 X-Axis Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 X-Axis Belt — Questions
Does this fit the D600 Pro2 HS?
No. The D600 Pro2 HS uses X-axis belt part 143007.
How tight should the new belt be?
Firm, with no slack or sag, but not so tight that the carriage feels stiff to move by hand. Recheck it after the first few prints.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 143004, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.