CreatBotD600 Pro2 Whole PlatformGenuine CreatBot Replacement Part
Whole build platform assembly for the CreatBot D600 Pro2
The CreatBot D600 Pro2 whole platform (part 181004) is the complete build platform assembly for the CreatBot D600 Pro2. On a printer with a build area this large, a small amount of warp or damage in the platform shows up across the whole plate as uneven first layers, poor adhesion in one corner and parts that come off the bed out of square. Replacing the whole platform returns the printer to the platform it shipped with. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 Whole Platform (Complete Build Platform Assembly), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Compatible CreatBot 3D printer
Check your model before you order. The D600 Pro2 HS uses a different platform (181005), and the earlier D600 Pro uses part 181003. Other CreatBot whole platforms include the D1000 (181006), D1000 HS (181007) and the F430 in 110V (181002) and 220V (181001) versions.
Why replace the complete platform
One part, one fit. The assembly arrives as a unit built for the D600 Pro2, so there is no mixing of components from different machines.
Faster repair. Swapping the whole platform is usually quicker than diagnosing and rebuilding a damaged assembly piece by piece.
Back to a flat reference. A flat, undamaged platform gives the leveling system a reliable surface to measure.
Genuine CreatBot part. The same platform design CreatBot uses in production.
Installation tips
Work with the printer cold, switched off and unplugged. Label or photograph each connector on the platform wiring before removal, and keep the mounting hardware together. Lift the platform out with support at both ends so it does not twist. Once the new platform is mounted and connected, move the Z axis through its full range to confirm nothing snags, then run bed leveling and a full plate first layer test before you start production work.
CreatBot D600 Pro2 Whole Platform (Complete Build Platform Assembly) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 Whole Platform (Complete Build Platform Assembly) — Questions
Does this fit the D600 Pro2 HS?
No. The D600 Pro2 HS has its own platform, part 181005.
My first layers are uneven. Is the platform the problem?
Possibly. Leveling sensor faults, Z axis issues and slicer settings can cause the same symptom. Contact Rev1 support and we will help you confirm the cause before you order.
Can Rev1 install it?
Yes. Rev1 Technologies is a certified CreatBot service provider and can replace and test the platform for you.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 181004, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.