CreatBotD600 Pro2 HS Z DriveGenuine CreatBot Replacement Part
Stepper motor driver, Z axis for the CreatBot D600 Pro2 HS
The CreatBot D600 Pro2 HS Z drive (part 115001) is an OEM stepper motor driver for the Z axis. CreatBot catalogs it under the D600 Pro2 HS name, and its listed fit is the CreatBot D600 Pro2. The Z axis sets layer height, stepping a fixed amount after every layer, and the Z drive supplies the motor current that makes each of those steps happen. On a printer with a build height like the D600 Pro2, a long print can include thousands of Z moves, so a weak driver shows up as uneven layers or parts that finish at the wrong height. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 HS Z Drive (Z-Axis Stepper Driver) for D600 Pro2, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the Z drive may need replacing
Banding or uneven layer lines that slicer changes do not fix.
The Z axis will not move, moves in jerks or the motor only hums.
Homing or bed leveling stops with an error on the Z axis.
Finished parts are noticeably off in height.
Check the lead screw, couplers and Z motor cable before replacing the driver. A binding screw or loose coupler causes many of the same problems.
Compatible CreatBot 3D printer
Because the part name and the listed fit differ, send Rev1 your printer model and a photo of the fitted driver if you are not sure this is the right module. The matching extruder driver in this family is part 115002, and the D1000 HS uses its own Z drive, part 115005.
Installation tips
Clear the build plate, then power the printer off and unplug it. Photograph the driver in place, note its orientation and swap in the new module the same way round. Reconnect the Z motor cable, home the printer, re-run bed leveling and print a tall test part.
CreatBot D600 Pro2 HS Z Drive (Z-Axis Stepper Driver) for D600 Pro2 Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 HS Z Drive (Z-Axis Stepper Driver) for D600 Pro2 — Questions
Why does the name say D600 Pro2 HS when it fits the D600 Pro2?
That is how CreatBot catalogs part 115001. The fit list for this part is the D600 Pro2. Rev1 can confirm the match for your serial number.
Will it fit the D1000 HS?
No. The D1000 HS Z axis uses part 115005.
Is this a genuine CreatBot part?
Yes, CreatBot part 115001, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.