CreatBotD600 Pro2 HS Y-Axis BeltGenuine CreatBot Replacement Part
Y-axis timing belt for the CreatBot D600 Pro2 HS
The CreatBot D600 Pro2 HS Y-axis belt (part 143008) is the OEM timing belt for Y-axis motion on the CreatBot D600 Pro2 HS. On this high speed printer, the Y belt handles rapid acceleration over a large build area. When it begins to stretch or wear, front to back accuracy suffers first, followed by layer shifts during fast moves. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 HS Y-Axis Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the Y-axis belt needs replacing
Prints shift toward the front or back, often during fast infill or travel moves.
Calibration squares are skewed, or Y dimensions are off.
Ringing on faces that run left to right across the printer.
Visible damage or a belt that will not keep its tension.
Compatible CreatBot 3D printer
The D600 Pro2 HS Y drive also uses a closed loop belt, part 143009, and its X axis uses part 143007. The standard D600 Pro2 uses Y-axis belt 143005, and the D600 Pro uses 143002.
Which Y belt is this?
CreatBot lists two Y belts for the D600 Pro2 HS. This part, 143008, is the Y-axis belt that moves the axis and is normally fixed at its ends. The closed loop belt, 143009, is a continuous loop of the kind used to carry drive between pulleys. Match the worn belt to the right part before ordering, and consider replacing both if they are the same age.
Installation tips
Turn off and unplug the printer. Photograph the belt route and the clamp at each end. If the Y axis has a belt on each side, tension both equally so the gantry stays square at speed. Fit the new belt, set the tension and move the axis by hand through its full travel. Home the printer and run a calibration square at normal print speed.
CreatBot D600 Pro2 HS Y-Axis Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 HS Y-Axis Belt — Questions
Which Y belt do I need, 143008 or 143009?
Part 143008 is the Y-axis belt. Part 143009 is the Y-axis closed loop belt. Rev1 support can help you tell them apart.
Will the D600 Pro2 Y belt fit my HS?
No. The D600 Pro2 uses part 143005. The HS needs part 143008.
Is this a genuine CreatBot part?
Yes, CreatBot part 143008, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.