CreatBotD600 Pro2 HS Filament HeaterGenuine CreatBot Replacement Part
Filament chamber heater for the CreatBot D600 Pro2 HS
The CreatBot D600 Pro2 HS filament chamber heater (part 182017) is the OEM heater for the filament chamber of the CreatBot D600 Pro2 HS. It warms the enclosed compartment that holds the spools, which keeps the filament dry as it feeds the printer. At high print speeds the hotend has less time to deal with moisture, so damp filament shows up fast as sputtering, uneven extrusion and rough surfaces. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 HS Filament Chamber Heater, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs it needs replacing
The filament chamber stays cold, the printer reports a filament chamber fault, or moisture symptoms appear on spools that went in dry. Check the heater leads and connector for damage. If you are unsure whether the heater or another component is at fault, Rev1 support can help.
Compatible CreatBot 3D printer
The standard D600 Pro2 uses part 182016 and the D600 Pro uses part 182015. The D600 Pro2 HS build chamber heater is a separate part, 182011.
Why keep the filament chamber heated
Protects moisture sensitive filament. Nylon, PC and PVA absorb water from the air and print poorly once they do.
Steady extrusion at speed. Dry filament melts and flows evenly, which the HS needs to hold quality at higher speeds.
Stronger parts. No steam bubbles means no hidden voids between layers.
Genuine CreatBot part built for the D600 Pro2 HS filament chamber.
Installation tips
Unload filament and remove the spools. Power the printer off, unplug it and let the filament chamber cool. Photograph the wiring before disconnecting the old heater, then fit the new one in the same position and route the leads away from the spools and filament path. Close the filament chamber, power up and confirm it warms and holds temperature. Load dry filament and run a test print at your usual speed.
CreatBot D600 Pro2 HS Filament Chamber Heater Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 HS Filament Chamber Heater — Questions
Is this the same part as the D600 Pro2 filament chamber heater?
No. The D600 Pro2 uses 182016; the D600 Pro2 HS uses 182017.
Does it replace a filament dryer?
It keeps dry filament dry during printing. A badly soaked spool should still be dried before loading.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 182017, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.