CreatBotD600 Pro2 HS Chamber HeaterGenuine CreatBot Replacement Part
Build chamber heater for the CreatBot D600 Pro2 HS
The CreatBot D600 Pro2 HS chamber heater (part 182011) is the OEM heater for the enclosed build chamber of the CreatBot D600 Pro2 HS, the high speed version of the D600 Pro2. Faster printing does not change how engineering materials behave: ABS, ASA, PC and nylon still shrink as they cool, and on a large build plate that shrinkage turns into warped corners and cracks between layers unless the chamber is kept warm. The chamber heater keeps the air around the part at a steady temperature so large parts stay flat and bond well. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 HS Chamber Heater (Build Chamber Heater), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the chamber heater needs replacing
The build chamber heats slowly or never reaches its set point.
A chamber heating error appears on the touchscreen.
Parts that used to print flat now warp or split at the same settings.
The heater or its wiring shows burn marks, melted insulation or a loose connector.
A faulty sensor, fuse, relay or control board can cause the same symptoms. Rev1 support can help you test before you replace.
Compatible CreatBot 3D printer
This heater is listed for the D600 Pro2 HS only. The standard D600 Pro2 uses part 182010 and the D600 Pro uses part 182009. For the D600 Pro2 HS filament chamber, which keeps spools dry, order part 182017.
Installation tips
Unplug the printer from mains power and allow the chamber to cool fully. Photograph the heater wiring and terminal positions before removal. Install the new heater in the same location with the original hardware, tighten every connection and keep the leads clear of the gantry and other moving parts. With the door closed, run a chamber heat cycle and watch the chamber temperature climb and hold before you start a print. If the printer is still under warranty, contact Rev1 first.
CreatBot D600 Pro2 HS Chamber Heater (Build Chamber Heater) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 HS Chamber Heater (Build Chamber Heater) — Questions
Will the D600 Pro2 heater work in my D600 Pro2 HS?
CreatBot lists separate parts for the two models. Order 182011 for the D600 Pro2 HS.
Is this the filament chamber heater?
No. This heats the build chamber. The D600 Pro2 HS filament chamber heater is part 182017.
Can Rev1 install it?
Yes. Rev1 Technologies is a certified CreatBot service provider and can diagnose, replace and test the heater.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 182011, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.