CreatBotD600 Pro2 Chamber HeaterGenuine CreatBot Replacement Part
Build chamber heater for the CreatBot D600 Pro2
The CreatBot D600 Pro2 chamber heater (part 182010) is the OEM heater for the enclosed build chamber of the CreatBot D600 Pro2. The D600 Pro2 is often bought to print large functional parts in engineering materials, and those materials need warm surrounding air. A heated chamber slows the cooling of each layer, which keeps internal stress low and stops large parts from curling, cracking along layer lines or lifting off the bed. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro2 Chamber Heater (Build Chamber Heater), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the heater has failed
Watch for a chamber that will not reach its set temperature, a chamber heating error on the screen, or warping that returns on jobs that used to print cleanly. Check for scorched leads or a loose connector. Because a sensor, fuse or board fault can look the same, Rev1 support can help you confirm the heater is at fault before you order.
Compatible CreatBot 3D printer
The D600 Pro2 HS uses a different heater (182011), and so does the earlier D600 Pro (182009). For the filament chamber on the D600 Pro2, order part 182016.
Why a working chamber heater matters
Flatter large parts. Warm air around the whole part reduces corner lift and warp on wide prints.
Better layer adhesion in ABS, ASA, PC and nylon, which can split between layers in a cool enclosure.
Consistent results. A chamber that reaches temperature reliably means the same settings give the same part every time.
Genuine CreatBot part designed for the D600 Pro2 enclosure.
Installation tips
Always disconnect mains power and let the chamber cool before working on a heater. Photograph the existing wiring and terminal positions, swap the heater using the original mounting hardware, and make sure no lead can contact a hot surface or moving part. Close the door, heat the chamber and confirm it reaches and holds its set point before you begin a print.
CreatBot D600 Pro2 Chamber Heater (Build Chamber Heater) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro2 Chamber Heater (Build Chamber Heater) — Questions
Does this fit the D600 Pro2 HS?
No. The D600 Pro2 HS uses part 182011.
What is the difference between 182010 and 182016?
182010 heats the build chamber. 182016 heats the filament chamber that holds the spools.
Can Rev1 do the repair?
Yes. Rev1 Technologies is a certified CreatBot service provider and an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 182010, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.