CreatBotD600 Pro Y-Axis BeltGenuine CreatBot Replacement Part
Y-axis timing belt for the CreatBot D600 Pro
The CreatBot D600 Pro Y-axis belt (part 143002) is the OEM timing belt for Y-axis motion on the CreatBot D600 Pro. Along with the X-axis belt it decides where every line is placed on the build plate. When the Y belt wears or loosens, prints shift front to back and parts stop coming out square, problems that are hard to miss on the large parts a D600 Pro produces. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro Y-Axis Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the Y-axis belt needs replacing
Layers step front to back partway through a print.
Calibration squares come out as parallelograms.
Front and back faces show ripples that X-facing walls do not.
Worn teeth, fraying or cracks, or a belt that will not stay tight.
Compatible CreatBot 3D printer
The D600 Pro Y drive also uses a closed loop belt, part 143003, and the X axis uses part 143001. The D600 Pro2 (143005) and D600 Pro2 HS (143008) each have their own Y-axis belt.
Y-axis belt or closed loop belt?
The D600 Pro lists two Y belts. This part, 143002, is the Y-axis belt that moves the axis and is normally secured at its ends. Part 143003 is the closed loop belt, a continuous loop of the kind used to carry drive between pulleys. If the belt you need to replace has clamped ends, this is the right part.
Installation tips
Switch off and unplug the printer. Photograph the belt path and both end clamps. Where the Y axis has a belt on each side, tension both sides evenly so the axis stays square. Fit the new belt, set the tension, run the axis through its full travel by hand, then home the printer and print a calibration square.
CreatBot D600 Pro Y-Axis Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro Y-Axis Belt — Questions
Which Y belt do I need for my D600 Pro?
Part 143002 is the Y-axis belt. Part 143003 is the Y-axis closed loop belt. Contact Rev1 support if you are unsure which one is worn.
Will it fit the D600 Pro2?
No. The D600 Pro2 uses part 143005.
Is this a genuine CreatBot part?
Yes, CreatBot part 143002, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.