CreatBotD600 Pro E1 Extruder MotorGenuine CreatBot Replacement Part
For the CreatBot D600 Pro
The CreatBot D600 Pro E1 motor (part 131021) is the OEM extruder motor for the first extruder (E1) on the CreatBot D600 Pro. The extruder motor turns the drive gear that grips the filament and pushes it into the hotend, so it controls exactly how much plastic reaches the nozzle. When it weakens or fails, the first thing you see is under-extrusion, gaps in walls and a clicking extruder. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D600 Pro E1 Extruder Motor, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the E1 motor needs replacing
The E1 extruder does not turn when you load or extrude filament from the touchscreen.
Repeated clicking or skipping on E1 while the nozzle and filament path are clear.
Thin or missing lines from the first extruder while the second extruder prints normally.
The motor stutters, vibrates without turning, or runs much hotter than the E2 motor.
A partial clog, a worn drive gear, wrong idler tension or a loose connector can look the same. Swapping the E1 and E2 cables at the board, where practical, is a quick way to tell a motor fault from a driver fault. Rev1 support can walk you through it.
Compatible CreatBot 3D printer
The matching motor for the second extruder is the D600 Pro E2 motor, part 131022, and the D600 Pro Z motor is part 131023. The D600 Pro2 uses different extruder motors (131024 and 131025).
Installation tips
Unload the filament and let the hotend cool, then power the printer off and unplug it. Note how the cable is routed and how the drive gear sits on the shaft before you remove anything. Mount the new motor in the same orientation, refit the drive gear so it lines up with the filament path, and check idler tension. Load filament and extrude a short length from the touchscreen to confirm smooth, steady feeding before you print.
CreatBot D600 Pro E1 Extruder Motor Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D600 Pro E1 Extruder Motor — Questions
Is the E1 motor the same as the E2 motor?
They are listed as separate parts. Order 131021 for E1 and 131022 for E2.
Will it fit my D600 Pro2?
No. The D600 Pro2 uses parts 131024 (E1) and 131025 (E2).
Is this a genuine CreatBot part?
Yes. It is CreatBot part 131021, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified CreatBot service provider.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.