CreatBotD1000 Y-Axis Closed Loop BeltGenuine CreatBot Replacement Part
Y-axis closed loop (endless) timing belt for the CreatBot D1000
The CreatBot D1000 Y-axis closed loop belt (part 143017) is the OEM continuous belt used in the Y-axis drive of the CreatBot D1000. Unlike an open belt with clamped ends, a closed loop belt is a single endless loop. Belts of this kind are usually used to carry drive between pulleys, for example from a motor to a shaft. Because it sits in the drive train, any slip or wear here affects the whole Y axis. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 Y-Axis Closed Loop Belt, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the closed loop belt needs replacing
Y-axis layer shifts that return even after the main Y-axis belt has been checked.
A chirping, ticking or grinding noise from the Y drive.
Cracks on the back of the loop, frayed edges or worn teeth.
The loop has stretched and the tensioner or motor mount has no adjustment left.
Compatible CreatBot 3D printer
The D1000 also uses an X-axis belt (143015), a Y-axis belt (143016), a Z-axis motor belt (143018) and a Z-axis timing belt (143019). The D1000 HS has its own Y-axis closed loop belt, part 143022.
Why a closed loop belt is different to replace
An endless belt cannot be threaded through and clamped like an open belt. It has to be slipped over its pulleys, which usually means loosening the motor mount or tensioner to create slack, and sometimes removing a pulley or guard. Allow more time than for an X or Y belt, and take photos as you go.
Installation tips
Power off and unplug the printer. Note the motor or tensioner position before you loosen it so you can return close to the original tension. Fit the new loop over both pulleys with the teeth fully engaged, re-tension, and turn the drive by hand to check it runs smoothly with no rubbing. Home the printer and run a test print with long Y moves.
CreatBot D1000 Y-Axis Closed Loop Belt Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 Y-Axis Closed Loop Belt — Questions
Is this the same as the D1000 Y-axis belt?
No. The Y-axis belt is part 143016. This is the closed loop belt, part 143017.
Will it fit the D1000 HS?
No. The D1000 HS uses part 143022.
Can Rev1 install it?
Yes. Rev1 Technologies is a certified CreatBot service provider and can replace the belt and check the rest of the Y drive while the printer is open.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 143017, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.