CreatBotD1000 Whole PlatformGenuine CreatBot Replacement Part
Whole platform (complete build platform assembly) for the CreatBot D1000 HS and D1000
The CreatBot D1000 whole platform (part 181006) is the complete build platform assembly for the CreatBot D1000, and CreatBot lists it for the D1000 HS as well. It replaces the platform as a whole unit instead of one component at a time. The D1000 has one of the largest build areas in the CreatBot range, and on a platform that size flatness and even heating decide whether big parts print successfully. A platform that has been bent, damaged or worn out undermines every print that follows. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 Whole Platform for D1000 and D1000 HS 3D Printers, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Compatible CreatBot 3D printers
CreatBot also lists a dedicated D1000 HS whole platform, part 181007. The D600 Pro (181003), D600 Pro2 (181004) and D600 Pro2 HS (181005) each use their own platform.
When a whole platform makes sense
Physical damage. A bent or warped platform that leveling can no longer correct.
Multiple failures. Several platform components worn or failed at once.
Faster recovery. Swapping a complete assembly gets a production printer running again sooner than a piece-by-piece rebuild.
Fleet spares. One part number listed for both the D1000 and D1000 HS.
If only one component has failed, such as the silicone heater, Rev1 can help you replace just that part instead.
Installation tips
Turn the printer off, unplug it and let the platform cool fully. The assembly is large and heavy enough that two people should handle it. Photograph all cables and connectors before disconnecting them and note the cable routing. Once the new platform is in place, secure the wiring so it cannot snag as the bed moves, heat the bed once to check it, then run the leveling routine and a full-plate first layer test.
CreatBot D1000 Whole Platform for D1000 and D1000 HS 3D Printers Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 Whole Platform for D1000 and D1000 HS 3D Printers — Questions
Should my D1000 HS use 181006 or 181007?
CreatBot lists both for the D1000 HS. Send Rev1 your serial number and we will confirm the right platform before you order.
Do I need to re-level after installing it?
Yes. Always run the leveling routine and a first layer test on a new platform.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 181006, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified CreatBot service provider.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Do you sell parts for several CreatBot printers?
Yes. If you are stocking spares for more than one CreatBot printer, ask us for a parts kit or a bulk quote.