CreatBotD1000 HS Drag Chain CableGenuine CreatBot Replacement Part
For the CreatBot D1000 HS
The CreatBot D1000 HS drag chain cable (part 160016) is the OEM cable that runs inside the drag chain of the CreatBot D1000 HS high speed large format printer. The drag chain guides this cable as the axis moves, and the cable carries the power and signal lines that the moving assembly depends on. High speed printing means faster moves and more bending cycles per hour, so this cable works harder than the cable on a standard speed machine. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 HS Drag Chain Cable, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Why replace it with the genuine cable
It plugs in exactly where the original did, with no adapters.
A drag chain cable is made to bend over and over along a fixed path.
Intermittent heater, sensor and fan faults caused by broken strands go away with a new cable.
The same cable the D1000 HS was built with.
Signs it needs replacing
Watch for faults that depend on where the axis is: a temperature reading that jumps, a fan that drops out, or an error that appears at one end of travel and clears at the other. Damaged insulation where the cable leaves the chain is another clear sign.
Compatible CreatBot 3D printer
The standard D1000 uses a different cable, part 160015. The D600 Pro2 HS uses part 160014.
Installation tips
Turn the printer off and unplug it. Label both ends of each connector and photograph the routing before you start. Transfer the cable into the chain one section at a time so it lies flat without twisting, then reconnect everything. Jog the axis slowly through its whole range and check that nothing pulls tight before you return to full speed printing.
CreatBot D1000 HS Drag Chain Cable Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 HS Drag Chain Cable — Questions
Is this the same cable as the standard D1000?
No. The D1000 uses part 160015. The D1000 HS needs part 160016.
How do I know the cable is the problem?
Faults that follow the position of the axis point to the cable. Rev1 support can help confirm it before you order.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 160016, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.