CreatBotD1000 E1 Extruder MotorGenuine CreatBot Replacement Part
For the CreatBot D1000
The CreatBot D1000 E1 motor (part 131027) is the OEM extruder motor for the E1 extruder on the CreatBot D1000. E1 and E2 are the printer's two extruders, and each has its own motor. The extruder motor turns the drive that pushes filament into the hotend, so it sets how much plastic reaches the nozzle. When it weakens or fails, the E1 extruder stops feeding reliably. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 E1 Extruder Motor, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the E1 motor may need replacing
The E1 extruder does not turn, or turns weakly, while E2 works normally.
Under-extrusion or gaps on E1 that remain after the nozzle and drive gear have been checked.
Buzzing, stuttering or excessive heat from the motor.
A damaged motor body, shaft or connector.
A clogged nozzle, worn drive gear or loose cable can cause similar symptoms. A quick test is to swap the E1 and E2 motor cables at the motors: if the fault moves with the motor, the motor is the likely cause. Rev1 support can talk you through it.
Compatible CreatBot 3D printer
Other D1000 motors: the E2 extruder motor is part 131028 and the Z motor is part 131029. The D1000 HS is a different printer with its own motors.
Installation tips
Power the printer off, let the hotend cool and unload the E1 filament. Photograph the extruder assembly and note how the motor, drive gear and cable are arranged. Transfer the drive gear if your assembly requires it, making sure it lines up with the filament path. Reconnect the cable, then load filament and extrude a test length on E1 before printing.
CreatBot D1000 E1 Extruder Motor Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 E1 Extruder Motor — Questions
What is the difference between E1 and E2?
They are the D1000's two extruders. Each has its own motor: E1 is part 131027 and E2 is part 131028.
Does it fit the D1000 HS?
No. The D1000 HS uses its own extruder motors, parts 131005 and 131006.
Is this a genuine CreatBot motor?
Yes. It is CreatBot part 131027, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.