CreatBotD1000 Cooling FanGenuine CreatBot Replacement Part
For the CreatBot D1000
The CreatBot D1000 cooling fan (part 150033) is the OEM print cooling fan for the CreatBot D1000 large format 3D printer. It blows air onto the plastic as it leaves the nozzle, so each line sets before the next one lands on it. Good part cooling is what gives you clean overhangs, tidy bridges and sharp small features, especially in PLA and other materials that need fast cooling. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 Cooling Fan, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the cooling fan needs replacing
Overhangs droop or curl and bridges sag where they used to print cleanly.
Small features and tips look melted or blobby.
The fan does not spin when the slicer calls for cooling, or spins slowly.
Clicking, buzzing or grinding from the print head.
Compatible CreatBot 3D printer
The D1000 uses four different fans: this cooling fan, the sink fan (150032), the power supply cooling fan (150034) and the cross flow fan (150035). The D1000 HS is a different machine and uses front and back cooling fans, parts 150005 and 150006.
Cooling fan or sink fan?
The two fans on the print head do different jobs. The sink fan runs whenever the hotend is hot and keeps the heat sink cool so filament does not soften too early. The cooling fan is controlled by your slicer and cools the printed part. If prints look soft and droopy, suspect the cooling fan. If you get clogs or under-extrusion, check the sink fan first.
Installation tips
Power the printer off and let the hotend cool before you work on the print head. Note the cable route and connector, and fit the new fan in the same orientation so air still points at the nozzle area. Keep the cable clear of moving parts and the heater block, then run a short print with cooling on to confirm the fan responds.
CreatBot D1000 Cooling Fan Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 Cooling Fan — Questions
Does this fit the D1000 HS?
No. The D1000 HS uses its own front (150005) and back (150006) cooling fans.
Can I print without the cooling fan?
Some materials print with little or no cooling, but most jobs need it. Replace a failed fan before printing PLA or fine detail.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 150033, supplied by Rev1 Technologies, an authorized CreatBot dealer.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.