CreatBotD1000 Chamber HeaterGenuine CreatBot Replacement Part
Build chamber heater for the CreatBot D1000
The CreatBot D1000 chamber heater (part 182012) is the OEM heater for the enclosed build chamber of the CreatBot D1000. The D1000 is built for very tall, large parts, and those are the parts most likely to warp, crack between layers or pull off the bed when the air around them is cool. A heated chamber keeps the whole part warm while it prints, which cuts down on the stresses that cause warping in materials such as ABS, ASA, PC and nylon. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot D1000 Chamber Heater (Build Chamber Heater), from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the chamber heater needs replacing
The chamber takes far longer than usual to warm up, or never reaches its set temperature.
The printer reports a chamber heating error.
Warping and layer splitting return on materials that used to print cleanly.
A heater, its wiring or its connector shows burn marks or physical damage.
A failed sensor, fuse, relay or cable can look the same. Rev1 support can help you test the heater before you replace it.
Compatible CreatBot 3D printer
The D1000 HS uses its own chamber heater, part 182013. The D1000 filament chamber heater (182018) is a different part that heats the filament chamber, not the build chamber.
Installation tips
Switch the printer off, unplug it and let the chamber cool. Heater circuits carry mains power, so never work on them with the printer connected. Photograph the wiring and terminal positions, then remove the old heater and fit the new one in the same position with the same hardware. Make sure every connection is tight and that no wire can touch a hot surface or a moving part. Heat the chamber with the door closed and confirm it reaches its set point before you start a print.
CreatBot D1000 Chamber Heater (Build Chamber Heater) Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot D1000 Chamber Heater (Build Chamber Heater) — Questions
Is this the same heater as the D1000 HS?
No. The D1000 HS uses part 182013.
Which materials benefit most from a heated chamber?
Materials that shrink as they cool, such as ABS, ASA, PC and nylon, especially on large parts.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 182012, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified service provider.
Why is there no photo of this part yet?
CreatBot has not supplied a product photo for this part yet. The part is identified by its CreatBot part number, and our team confirms it is the right part for your printer before it ships.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.