CreatBotCalibration CameraGenuine CreatBot Replacement Part
Calibration Camera for D400 HS, D600 Pro3 HS, D1000 Pro HS, D800 Ultra and D1200 Ultra
The CreatBot calibration camera (part 174001) is the camera module that CreatBot's newer HS and Ultra printers use for camera-based calibration. CreatBot lists it as the calibration camera, and it is shared across five current models. Camera-assisted calibration lets the printer measure rather than rely on manual adjustment, which makes setup more repeatable and reduces the time an operator spends dialing in a large format machine. If the camera fails, calibration routines that depend on it cannot complete correctly. Full specifications →
Genuine CreatBot part, shipped from Rev1 — your authorized CreatBot dealer and service partner. Not sure it fits? Call (248) 707-2950.
Genuine CreatBot Calibration Camera, from an authorized CreatBot dealer.
An authentic CreatBot replacement part, not a third-party copy. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in Auburn Hills, Michigan.
Signs the calibration camera needs replacing
The calibration routine reports a camera error or cannot find the camera.
The camera image is missing, frozen, blurred or distorted when calibration runs.
Calibration results are inconsistent from one run to the next after the lens has been cleaned.
The camera, its lens or its cable shows physical damage.
A loose cable or a dirty lens can cause the same symptoms. Check both first, and contact Rev1 support if the fault remains.
Compatible CreatBot 3D printers
One part number covers all five models, which makes it a practical spare to keep on hand if you run a mixed fleet of HS and Ultra printers.
Care and handling
Keep the lens clean and free of filament dust and fingerprints. Wipe it gently with a clean, lint-free cloth, and avoid solvents that could damage the lens or its housing. Handle the module by its body, not the cable.
Installation tips
Turn the printer off and unplug it before you disconnect the camera. Note the cable routing and connector, fit the new camera in the same position and orientation, and secure the cable so it cannot snag on the moving toolhead. Power up, run the calibration routine and check the results before printing.
CreatBot Calibration Camera Specifications
WHY REV1 TECH
Sold and Supported by Rev1 Technologies
Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US. Not sure which part your printer needs? Send us your printer model and serial number and our team will confirm the right part before it ships. We also handle installation, repair and preventive maintenance on CreatBot printers.
CreatBot Calibration Camera — Questions
Does one camera fit all of these printers?
Yes. Part 174001 is listed for the D400 HS, D600 Pro3 HS, D1000 Pro HS, D800 Ultra and D1200 Ultra.
Do I need to recalibrate after replacing it?
Yes. Run the printer's calibration routine after the swap and before your next print.
Is this a genuine CreatBot part?
Yes. It is CreatBot part 174001, supplied by Rev1 Technologies, an authorized CreatBot dealer and certified CreatBot service provider.
Is this a genuine CreatBot part?
Yes. Rev1 Technologies is an authorized CreatBot dealer and certified CreatBot service provider in the US, and every part we sell is a genuine CreatBot part.
How do I confirm it fits my printer?
Send us your printer model and serial number, or call (248) 707-2950, and our team will confirm the right part before it ships.
Can Rev1 install it for me?
Yes. We handle installation, repair and preventive maintenance on CreatBot printers. Ask us about on-site or depot service.