AESUB Dice3D Scanning Reference Dice (12-Pack)Drop-In Reference Points for Faster Scan Prep
Reusable Reference Dice for 3D Scanning
AESUB Dice are reusable reference targets for quick, repeatable scan preparation. Each die carries retro-reflective 6 mm targets and attaches in seconds by magnet or M4 thread — drop them around a part or fixture and your scanner instantly has fixed reference points to align and stitch captures. A box of 12, ready to reuse job after job. Genuine AESUB, Made in Germany. Full details →
In stock in the USA — ships from Rev1. Questions? Call (248) 707-2950.
Genuine AESUB, Made in Germany. US Stock, Fast Shipping.
Authentic AESUB, supplied and supported by Rev1 Technologies from Auburn Hills, Michigan — we run a metrology and scanning lab and can set up your workflow. Not a re-labeled substitute.
Reference Points You Can Reuse.
3D scanners use fixed reference targets to align and stitch multiple captures into one accurate model. AESUB Dice give you sturdy, reusable targets that snap into place by magnet or thread — faster to set up than stick-on dots for fixtures and repeat setups, with no consumable to replace.
Fixed Reference in Seconds.
Each die gives your 3D scanner a clean retro-reflective 6 mm target on a solid, stable body — place a few around the part and the software locks alignment. Reusable, so there’s no peeling and re-applying dots for repeat jobs.
Magnet or M4 Thread.
Attach dice to steel fixtures and jigs with the built-in magnet, or screw them into an M4 hole for a fixed, repeatable position — ideal when you scan the same setup again and again.
A Box of 12, Ready to Go.
Twelve dice per box gives you enough to ring a part or populate a fixture, and because they’re reusable they pay back fast on repeat scanning. Pair them with AESUBdots and sprays for a complete scan-prep kit.
AESUB Dice — Details
WHY REV1 TECH
Targets From the People Who Scan.
Rev1 Technologies runs a metrology and 3D-scanning lab in Auburn Hills, MI — so we stock AESUB and use it, and can set up your scan-prep workflow end to end.
We stock the AESUB range and the scanners it’s used with — buy from a team that can set up the whole workflow.
FAQ
Frequently Asked Questions
What are AESUB Dice for?
They’re reusable reference targets for 3D scanning — drop them around a part or fixture and your scanner uses their retro-reflective faces to align and stitch captures, without applying stick-on dots.
How do they attach?
By built-in magnet on steel surfaces, or by M4 thread for a fixed, repeatable position. That makes them ideal for jigs and fixtures you scan repeatedly.
How many come in a box?
Twelve dice per box — enough to ring a part or populate a fixture, and reusable job after job.
Which scanners do they work with?
Laser and retro-reflective 3D scanners that read retro targets. Not sure about your setup? Tell us your scanner and we’ll confirm.
Do they replace stick-on dots?
For fixtures and repeat setups, yes — they’re faster and reusable. For one-off scans on the part surface itself, AESUBdots are still the go-to. Many labs use both.
Is this genuine AESUB?
Yes — genuine AESUB, Made in Germany, supplied and supported by Rev1 Technologies from Auburn Hills, Michigan, and held in US stock.